Ribimex Ribitech PE100/200PT Manual De Instrucciones Y Mantenimiento página 10

Do not use 2 or more electric hoists to lift one same item.
- Do not lift heavy goods aslant; do not use the electric hoist for dragging goods on the
ground.
- Do not lift stationary goods or fix loads.
- Never lift or transport persons.
Do not stand under the load when it's lifting goods.
- Before hooking the load, press the button before loading, to make sure the distance
between the load and steel rope is minimal then lift the load.
- The user shall lift the load from the ground with the minimum speed available at the hoist.
The rope shall be tightened and shall not be in the slack-condition when the load is being
lifted from the ground
- Position Limit device is an safety insurance equipment to prevent it from going beyond the
limit when lift or lower the load.
- Do not use it as travel switch, never disassemble it.
- Do not leave heavy items suspended for a long time, so as to avoid permanent strain on
parts and to prevent accidents.
- Excessive inching (e.g. giving short pulses to the motor) shall be avoided.
- Do not transport hot molten masses
- In the event that emergency stop is triggered, please reset it before operation
- A-weighted emission sound pressure level at the operator's position is below 80dB.
INSTALLATION
The hoist "standard version" is provided with a specially designed bracket system which
allows mounting on a frame.
Check your power supply (volt-hertz) corresponds to those indicated on the machine rating
plate. Then plug in. If an extension cord is needed, it is absolutely important to respect the
data in the table below:
EXTENSION LENGTH
Up to 20 m
From 20m to 50 m
MAINTENANCE
- Please check the wear degree of electric hoist and go on comprehensive maintenance,
usually once every year.
- Ensure that all moving parts are adequately greased or oiled. Such as hook, drum shaft,
gearbox and shaft etc. Lubricate regularly (e.g. every six months.). Do not grease the cable.
- Pay attention to the abrasion of the hook. If the abrasion area of the hook exceeds 10% of
its nominal size, please replace it with a new one.
- Brake System:
kg. x1
CABLE SECTION (mm
1.5 mm
2.5 mm
2
)
kg. x2