Installation Instructions; Gas Connection - Trigano VDL AR85W Manual De Usuario E Instalacion

3 Installation Instructions

1. The refrigerator is designed to install into enclosure in the vehicle. No clearance is required on both sides.
Bottom must be leveled very well; particularly a cut-out should be left for hinge to access.
2. The floor must be solid and level and must be able to support the weight of the refrigerator and contents. Never
install the refrigerator directly on carpeting.
3. When installing the refrigerator into the enclosure recess, all areas within the recess must be sealed to prevent
exhaust fumes from entering the living space. It is recommended to use sponge strip to seal the rear part, including
the combustion system, from the living space. Make sure the sponge is compressed well for good seal.
4. A "T" shape exhaust pipe extension is provided and should be fitted.
5. The refrigerator must be secured in place with four screws, two on each side.
6. The opening of the enclosure should be at least 524 mm wide, 580mm deep and 837mm high.
7. A lower vent and an upper vent are required for ventilation. Opening of the both vents should be 250cm
minimum.
Three typical installations are illustrated as below.
GB F
Ventilation grille Grille de ventilation
Ventilation aperture Ventilation basse

Gas connection

The refrigerator is designed to work on LPG gas, not natural gas or town gas.
Check that the pressure of supplied gas is 30 mbar.
A suitable threaded coupling must be used to connect the gas pipe to the inlet.
Leakage test must be carried out after the connection is done.
Never use open flame to do leakage check.
Trigano-VDL AR85W / AR95 OM
Oct 2016 V10
D I
L ü f t u n g s g i t t e r
Grata ventilazione
Permanentbelüftung Ventilazione bassa
E NL
rejilla de ventilación ventilatierooster
Abertura ventilación Permanente-ventilatie
Page 10 of 112
2