Remote Control - Linea DOMO DO360A Manual De Instrucciones

Press the arrow buttons to select the time. The max time selection is 24 hours.
After finishing the selection, the time will start to countdown on the display until "auto on" or "auto off",
depending on the selection you made.
You can cancel the timer function at any time by pressing the "on/off" touch.
When the error code E1 or E2 is displayed, the timer selection will be canceled.
7. SWING touch
To adjust the air direction.
8. FOLLOW ME indicator light
If you set the FOLLOW ME function, this indicator light will illuminate. You can only activate this function
with the remote control.
9. LED display
Will show het temperature and timer selections. When the "dry or "fan" mode is selected, the display will
show the room temperature.

REMOTE CONTROL

· The remote control will only function within 8 m of the airco. Point the remote in
the direction of the airco. The transmission will be confirmed with a beep signal.
· The airco will not react to the remote if the signal is blocked by curtains, doors or
other materials.
· Make sure the remote doesn't get wet. Don't expose the remote to direct sunlight
or heat.
· When the infrared sensor on the appliance is positioned in direct sunlight it is
possible that it won't react to the remote control. Make sure there is no direct
sunlight on the infrared sensor.
· When other electrical appliances are reacting to the remote control, remove them
further away from the airco or contact your supplier.
· Don't use old and new batteries at the same time in the remote control. Don't use
two different types of batteries in the remote control.
· Remove the batteries from the remote, when you won't use it for a longer periode
of time. (more than two months)
· Recycle used batteries correctly.
Batteries
· The remote control works with 2 AAA (R03/LR3) batteries.
· Remove the cover of the batterie compartment, by pressing down on it and sliding it out of the
remote.
· Place the batteries, make sure to follow the indications + and – indicated in the
batterie compartment.
· Place the cover back on the batterie compartment.
· NOTE : When removing the batteries all selections will be deleted. When placing
ON/OFF
new batteries you have to reinstall all the selections.
MODE
FAN
SLEEP
54
DO360A
SHORT
CUT
TIMER
ON
TEMP
TIMER
OFF
FOLLOW
SWING LED
ME
ON/OFF SHORT
CUT
TIMER
MODE
ON
TEMP
TIMER
FAN
OFF
FOLLOW
SLEEP
SWING LED
ME