Operation Instruction; Connection Panel Directory; Ap70 - Connection Panel Dictionary; Ap70 - Operation Panel Dictionary - RADIOEAR AP70 Manual De Instrucciones

3.

Operation Instruction

3.1

Connection Panel Directory

3.2 AP70 - Connection Panel Dictionary

Position: Symbol:
1 Out
2 Out
3 In
4 In
5 Pre-set
6 Pre-set
7 Remote
8 Remote
9 Power
10
Input Level
The input sensitivity for CH1 and CH2 are controlled by the buttons (5) and (6) "Preset" on the connection panel. Do
not adjust the buttons (5) and (6) when the system is calibrated.
Remote power on
The amplifier can be switched on and off remotely. In the position "Normal mode" (8) can only be switched on and off
by the Main switch (10). In the position "Remote controlled" the amplifier can be turned on by applying 5VDC at the
Remote plug (9), 0VDC will turn of the amplifier.

3.3 AP70 - Operation Panel Dictionary

Position: Symbol:
10 Power
11
12 Power
AP70 Instructions for Use - English
Date: 2020/03
Function:
Plug for speaker CH1
Plug for speaker CH2
Plug for input signal CH1
Plug for input signal CH 2
Input sensitivity adjustment for CH1
Input sensitivity adjustment for CH 2
Input
Remote power on Controlled / Normal mode
Plug for Remote power on
Ground terminal for setup calibration
Function:
Mains power switch
Overload / Over temperature indicator
Power indicator
Page 7/14