König Electronic CMP-BARSCAN21 Manual De Uso página 2

Barcode scanner
Installing the USB interface scanner
To install the USB interface scanner the host device should have a USB port to receive data from the scanner.
Follow the steps as listed below:
1.) Make sure that the scanner has the right connector for the USB port of the host device.
2.) Connect the cable to the USB port of the device.
3.) If the LED indicator lights up and the buzzer sounds, the scanner is ready for use.
Configuration of the barcode scanner
Setup procedures
1.) Locate a group that contains the parameters to be changed.
2.) Scan the "Enter group #" label. The scanner will make a beeping sound to indicate that setup is in
progress.
3.) Scan the label representing the parameter to be changed.
4.) Scan the "Exit" to end the group currently selected, the scanner will beep.
5.) Repeat the procedure for the other groups, including the parameters to be changed.
Example 1:
Set the operating mode to "Continuous mode".
1) Scan "Enter Group 5".
2) Scan "Continuous/Trigger off".
3) Scan "Exit".
Example 2:
Assign the preamble string as "#", and postamble string as "END"
1) Scan "Enter Group 6"
2) Scan preamble
3) Refer to ASCII Table (page 50) and find the code number in hex decimal: # ASCII => 23 hex
The two digit numbers are: 2 3
4) Refer to Table-Hex: HEXADECIMAL (page 49) and scan the two digit labels accordingly.
5) Scan the "Confirm" label in Table-Hex
6) Scan "postamble"
7) Refer to the ASCII Table for the code numbers in hexadecimal (E => 45, N => 4E, D => 44)
8) Refer to Table-Hex: HEXADECIMAL (page 49) and scan the six digit labels consecutively.
4 5 4 E 4 4
9) Scan the "Confirm" Label in Table-Hex.
10) Go back to Group 6 and scan Exit.
Example 3:
Fixed Barcode Length Setting (i.e. Group 9-1 Interleaved 2 OF 5, Barcode Length= 15 digits):
1) Scan the Enter Group 9-1 Label
2) Scan the Length Define Label
3) Scan the Four Digit Labels in Table Hex (Page 49)
Tips:
• Refer to the Hexadecimal-Decimal Conversion Table (page 52) to get the barcode length in
Hexadecimal Number 15 dec => 0F hex
• The Four Digit numbers are: 0 F 0 F
• Refer to the Table-Hex: HEXADECIMAL (page 49) and scan the Four digit Labels accordingly.
4) Scan the Confirm Label in Table-Hex: HEXADECIMAL (Page 49)
5) Go back to Group 9-1 and scan the "Exit" Label.
Example 4:
3-Set Barcode Length Setting (i.e. Group 9-4: CHINA POSTAGE, the 3 Barcode Length Settings are as
below):
11 digits
28 digits
43 digits
ENGLISH
2