Installing Batteries - HoMedics BPW-200 Manual De Usario

BPW-200IB_ENGSP.qxd 10/24/05

INSTALLING BATTERIES

1. The battery cover is
located along the right
side of the monitor.
Place thumb on arrow
and remove battery
cover by pressing and
pushing cover in the
direction of the arrow.
2. Install lower battery first
according to the polarity
indications inside the
compartment. This bat-
tery should be in the
bottom position as
shown in figure 2.
Battery Type: 2 Alkaline
LR03 (AAA) size
3. Place in the other
battery, according to
the polarity indications
inside the compartment
and as shown in figure 3.
11:23 AM Page 13
1.
2.
3.
13
4. Replace the cover
by sliding it back
into place.
Replace the batteries if:
1. The weak battery
symbol appears in
the display.
2. Nothing appears in the
display when the power
is switched on.
As the supplied batteries are for test only,
they may be discharged earlier than batter-
ies you buy in stores. Replace the batteries
in pairs. Remove batteries when unit is not
in use for extended periods of time.
Note: Batteries are hazardous waste. Do
not dispose of them together with
the household garbage.
14
4.