Assembly Instructions - Alda RP-ALGE-M Manual De Usuario

User Manual
Garden Utility Cart

ASSEMBLY INSTRUCTIONS

1. Turn the cart bed (A) upside down. If necessary, use the cardboard from the product carton to prevent scratching
and damage to the nish of the cart.
2. REAR AXLE ASSEMBLY
a). Align the two holes in the rear axle support (G) with
the carriage support bolt (II) which were welded on the
bed at the rear of the cart bed (A).
NOTE: The rear section of the cart has a total of 6 holes.
b). Attach an 8 mm washer (FF) and an 8 mm nut (GG) to
the end of each bolt.
NOTE: Hand-tighten the connection. Do not
tighten completely.
c). Insert the end of the left rear axle brace (H) onto the side
of the rear axle support with the welded spacer bushings
facing outward. Repeat this step for the right rear axle
brace (I).
d). Align the holes on the at ends of the left and right axle
braces with carriage support bolts (II) which are welded
on the bed of the cart.
NOTE: If you experience di culty lining up the holes,
loosen the bolts on the rear axle support until the
holes on the braces align.
e). Attach an 8 mm washer (FF) and a 8mm nut (GG) to
the ends of each bolt. (see gure 1).
NOTE: Once attached, tighten all bold
connections from previous steps.
6
Hardware Used
4