Care And Maintenance - Alda RP-ALGE-M Manual De Usuario

Garden Utility Cart
ASSEMBLY INSTRUCTIONS - continued
5. PULL HANDLE ASSEMBLY
a). Remove the large pin (JJ) from the plastic
coupling (N).
b). Insert the end of the pull handle (O) into the
plastic coupling (N).
NOTE: Make certain the holes in the pull handle
are aligned with the holes in the plastic coupling.
c). Place the pull handle (O) and plastic coupling (N)
assembly into the yoke (L).
d). Align the holes in the pull handle and plastic
coupling with the holes on the yoke.
e). Insert the large pin (JJ) through the aligned holes
and secure the connection with a washer (FF) and
a lock pin (CC). (see Fig. 4)
Hardware Used
Large Lock Pin
8 mm Washer
6. RUBBER MAT ASSEMBLY
a). Place the rubber mat (Q) onto the cart bed. This can be removed if not needed.
7. TIRE INFLATION
a). Before attempting to operate the cart, check the air pressure of each tire.
b). If additional in ation is needed, use only a hand-operated air pump
c). Do NOT exceed 30 PSI as damage to the tires and/or personal injury could result.

CARE AND MAINTENANCE

• Check for loose fasteners before use.
• At the beginning of each season lubricate the pivot bolt and bearings with light machine oil.
• Grease the wheel bearings periodically, using general purpose grease.
• Check tire pressure regularly and in ate if needed. Do not over in ate.
• Cover or store out of weather when not in use.
x 1
Large Pin
x 1
7
User Manual
x 1
9