Waring Commercial MX1500XTSEE Manual De Instrucciones página 5

1. Plug the power cord into AC outlet. Press the STANDBY
to turn the unit On. The blue LCD backlight will turn on and the words
WARING COMMERCIAL will appear, indicating that the power is On.
After 5 seconds, the blender enters Standby Mode.
NOTE: In standby mode, the blender is awaiting directions and will read
PRESS ANY BUTTON TO BLEND.
. The motor speed can be adjusted by pressing the
buttons. Speed ranges from 15% to 100%.
100%
50%
15%
The SPEED UP
in 1% increments and the SPEED DOWN
motor speed and the display in 1% increments. Holding down either
button will quickly scroll through speeds.
Using the SPEED UP
motor speed. If no speed is selected, motor will default to previously
programmed speed.
NOTE: The motor does not run at the newly set speed until the START/
STOP button is pressed. If START/STOP
within 5 seconds, the new speed setting will be stored for next use and
the blender will return to Standby Mode; the display will once again read
PRESS ANY BUTTON TO BLEND.
3. Press START/STOP
continuously at the set speed. The LCD will display the motor speed in
percentage. Default speed (percentage) is at 100%. Motor speed can be
changed while blender is running by simply pressing the SPEED UP
or SPEED DOWN
4. To stop continuous blending operation, press the START/STOP
button or press any of the reprogrammable station buttons.
Your unit comes equipped with two Pulse options: Normal PULSE
Maximum PULSE
– once released, the unit will shut off.
1. To use Max PULSE option, press the
motor at 150% speed. The LCD will read "MAX PULSE SPEED: 150%.
. To use Normal PULSE option, press the
the motor at 100% speed. The LCD will read NORM PULSE SPEED:
100%.
3. The MX1300/MX1500 allows you to set the pulse to your desired speed.
While blending at Normal PULSE speed, the motor can be adjusted.
OPERATION
0,000 RPM's
10,000 RPM's
3,000 RPM's
button will increase the motor speed and the display
and SPEED DOWN
button to turn the blender on. Blender will run
Button.
PULSE FEATURES
. Note: The PULSE buttons are momentary switches
button will decrease the
PULSE Button. This will run the
PULSE button. This will run
5
button
or SPEED
buttons, set desired
button is not pressed
and