Possible Anomalies - Solter OPTIMATIC 100 Manual Del Usuario

ADJUSTING HEADGEAR
Headgear top (Position W)
Adjusting headgear for proper depth on the head to ensure correct balance and stability.
Headgear Tightness (Position Y)
Pressing the adjusting knob located on the back of the headgearand turn left or right to a desired
tightness.
Distance Adjustement (Position Z)
Adjust the distance between the face and the lens by loosening both outside tension knobs and press
inward to free from adjustment slots. Move forward or back to desired position and retighten.
(Both sides must be equally positioned for proer vison)
Angle Adjustement (Position X)
Four pins on the right side of the headgear top provide adjustment for the foward tilt of the helmet.
To adjust, loosen the right outside tension adjustment knob then lift on the control arm tab and move it
to the desired position and retighten tension adjustment knob.

POSSIBLE ANOMALIES

PROBLEM
Irregular filter darkening
The filter does not darken or it flashes
(Automatic filters)
Slow filter response(Automatic filters)
Insufficient vision
SOLTER SOLDADURA S.L.
POSIBLE SOLUTIONS
The regulating tape has been incorrectly positio-
ned or the helmet angle is not appropiate to your
vision.
The frontal filter protector is damaged or is unfit
for use.
The sensors are dirty.
The welding current is too low.
The working temperature is too low.
Frontal filter protectors or rear protectors are dirty.
Incorrect protection range.
Insufficient light in the working.