Model:
Maximum work
pressure:
Abrasive dapacity:
Dimension:
Tare weight:
Air entrance valve for remote
1
CD 12
control
2
CD 16
Connection AT - R5
3
CD 15
Nylon tube Ø 4
4
CD 20
Fast clutch crank
5
CD 11
Remote control exhaust valve
6
CD 10
Relay valve
7
CD 25
Rubber holder 1/8 = Ø 5
8
CD 9
Connection tube
9
RA 16
Fast joint
10
RA 16
Fast clutch
11
TU 6
Tube Drago
12
CD 13
Remote control lever group
CB 24 REMOTE CONTROL
Starting and using the remote control sandblasting
machine
1. Make sure that the valves E - F are closed (the handle
must be perpendicular to the flowing direction of the fluid).
2. Connect a flexible tube of air delivery to the fast
connection A.
3. Fill the machine with abrasive by the loading
funnel B, making sure that it is provided with sieve;
4. Connect the flexible tube for abrasive to the fast
connection C.
5. Seize the nozzle-holding launch and press the remote
control lever G in order to make the
closure head automatically close and then pressurize the
sandblasting machine.
6. While still holding the nozzle-holding launch and
keeping the lever G pressed, open completely the air
regulation valve E; open slowly the abrasive regulation
valve F until you get the right mixture air/abrasive. After
each regulation made with the valve F wait a moment,
CB 24
so that the mixture air/abrasive can have time to become
uniform.
8 bar
7. To stop the machine let the lever G free.To stop and start
lt. 24
the machine again act on the remote control lever G only.
cm. 60x40x80 h
Act on the valves E and F only if you want to change the
30 kg
mixture air/abrasive.