Opex OMATION Envelopener 410 Serie Manual Del Operador página 80

8. The display will return to the Run screen, with the job name displayed at the
top. At this time, you should set the cutter depth knob (Figure 4-10) for the
desired cut. Position 1 is the shallowest cut, and 3 is the deepest.
9. Once ready to begin, use the arrow buttons to highlight Run, and then press
Enter to start the machine (Figure 4-11). The screen will display "RUN
MODE ACTIVE" and elapsed run time.
40
OMATION® Series 410 Envelopener™ Operator Manual
Figure 4-10: Setting the cut depth
Figure 4-11: Starting the machine
OPEX Corporation
No Cut
Select RUN,
then press Enter
3
2
1
Operation