Emission Compliance Period (Small Off-Road Gas Engines); Emission Control System Certification Label (Small Off-Road Gas Engines); Operating Safely - Great Dane Scamper HG GBD10025 Manual Del Operador

Cortacésped
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DANGER
• Keep hands and feet away.
CAUTION
• Do not operate mower without chute deflector, mulching
plate or complete grass catcher assembly in position.
• Do not remove grass catcher, mulching plate or raise the
chute deflector until engine and blade(s) have stopped.
Emission Control System Certification Label
(Small Off-Road Gas Engines)
NOTE: Tampering with emission controls and
components by unauthorized personnel may result in
severe fines or penalties. Emission controls and
components can only be adjusted by EPA and/or CARB
authorized service centers. Contact your Great Dane
Equipment Retailer concerning emission controls and
component questions.
The presence of an emissions label signifies that the
engine has been certified with the United States
Environmental Protection Agency (EPA) and/or California
Air Resources Board (CARB).
The emissions warranty applies only to those engines
marketed by Great Dane that have been certified by the
EPA and/or CARB; and used in the United States and
Canada in off-road mobile equipment.
SAFETY
Emission Compliance Period (Small Off-Road
Gas Engines)
If your engine has the emission compliance category listed
on the emission control system certification or air index
label, this indicates the number of operating hours for which
the engine has been certified to meet EPA and/or CARB
emission requirements. The following table provides the
engine compliance period in hours associated with the
category found on the certification label.
Agency
MX9293 MX9261
EPA
EPA
EPA
CARB
CARB
CARB

Operating Safely

• Do not allow operation or service of the machine by
children or untrained adults.
• Read the operator's manual and study the safety and
MX9294 MX9261
operation sections before operating the machine.
• Operate the machine in an open, unobstructed area
under the direction of an experienced operator.
• Learn the use of all controls.
• Operator experience is required to learn the moving,
stopping, turning and other operating characteristics of the
machine.
• Inspect machine before you operate. Be sure hardware
is tight. Repair or replace damaged, badly worn, or missing
parts. Be sure guards and shields are in good condition
and fastened in place. Make any necessary adjustments
before you operate.
• Do not operate mower without discharge chute or entire
grass catcher in place.
• Check before each use that operator presence controls
are functioning correctly. Test safety systems. Do not
operate unless they are functioning correctly.
• Do not change the engine governor setting or overspeed
the engine.
• Check park brake function before operating. Adjust or
service park brake as necessary.
• Stop machine if anyone enters the area.
• Never raise mower decks when blades are running.
Safety - 2
Category
Hours
C
250
B
500
A
1000
Moderate
125
Intermediate
250
Extended
500

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido