exonda S32 Manual De Instrucciones página 43

8 Operating principles, model S32
8
8.1
In the basic setting, the temperature is at level 4; all heating heaters are selected,
the hair length is set to short hair and the Client button is at normal.
The basic setting is achieved
when the appliance is switched on
automatically 10 minutes after the last treatment
manually by pressing the "CLEAR" button
8.2
start the appliance using the "PERM" button
The program starts at temperature level 4
During the development time, the temperature sensor permanently monitors
NOTE
the temperature at the client's head and automatically offsets deviations
from the optimal temperature.
The appliance switches off automatically after the development time has
elapsed. Now check your test roller to ascertain whether the desired perm
effect has been achieved. If not, you can enter a chosen post-development
time by pressing the Time selection button. Now restart the appliance using
the "PERM" button
8.3
Enter the desired development time using the Time selection buttons
start the appliance using the "COLOR" button
The program starts at temperature level 4
can be increased or decreased manually using the "Temperature Setting"
button
8.4
Select the required drying time using the Time selection buttons
Start the appliance using the "COLOR" button
Special feature for partial drying
The hair length can be taken into account using the hair length button
the hair is drying partially.
Operating principles, model S32
Basic setting
Perm treatment
.
Colour, highlighting and semi-permanent colour
treatments
.
Partial drying/Pre-drying (without blower)
43
.
.
.
.
. If required, the temperature
.
.
when
GB
D
D
and