Cleaning The Serving Units And The Filter Holder; Cleaning The Tray And The Cup Support Grill; Cleaning The Steam Spout; Substitution Of Boiler Water - SM 100 Serie Manual De Uso Y Mantenimiento

8.1 Cleaning the serving units and the filter holder

1) Detach the filter cup from the serving unit, remove the coffee grounds and replace the filter present with
the blind filter (without holes) provided with the machine.
2) Using the brush, clean the seat in the unit in which the filter cup is inserted.
3) Insert the cup in the unit and, without latching it completely, press the continuous flow button.
4) Let water overflow from the filter holder. This will clean the serving group.
5) Stop the water flow and insert the filter cup in the unit.
6) Start the continuous flow and then stop it after a couple of seconds; repeat this operation a few times
(this is to clean the drain duct and the solenoid of the unit).
7) Clean the perforated filter and place it back into the cup. Let the water flow for a couple of seconds to
clean the filter, the cup and the spouts.
8) Repeat these operations on all the serving units.

8.2 Cleaning the tray and the cup support grill

The lower cup support grill 5 must be kept clean at all times; during the normal use of the machine, it is suffi-
cient to clean it with a sponge or a moist cloth. At the end of the working day, clean the tray and the grill also
in the internal areas using warm water and neutral detergent.

8.3 Cleaning the steam spout

Clean the steam spout with a sponge or a moist cloth at the end of the working day to remove all traces of milk or other
substances that inevitably form during the normal operation of the machine. Open the steam tap, placing the spout in
the tub, to remove any residues which may have accumulated in the spout.

8.4 Substitution of boiler water

To change the water inside the boiler, proceed as follows:
1) Cut off the power supply to the machine by turning the main switch 1 to position 0 (zero).
2) Remove the tub and the cup support grille and open the boiler drain tap.
3) Open a steam drawing valve to facilitate the draining of the water until the end of the operation.
4) When water no longer comes out of the boiler, close the boiler drain and the steam drawing tap.
5) Charge the machine with water following the instructions of paragraph "Charging the water in the boi-
ler".
38
-