Assembly - Attaching The Fan Blades; Attaching The Blades To The Blade Brackets - HAMPTON BAY 91469 Guía De Uso Y Cuidado

Assembly - Attaching the Fan Blades

1
Fastening the blade brackets to
the motor
IMPORTANT: Remove the rubber stopper on the black bracket
below the motor in order to attach the blade assembly to
the motor. Replace the rubber stopper to prevent water from
entering the switch housing and to reduce the risk of fire,
electric shock, or other personal injury.
NOTE: Your fan features revolutionary advancements for quick
and easy blade installation.
□
Fasten the blade bracket to the fan-motor housing (D) by
inserting the alignment post into the slot on the bottom of the
motor and tightening the blade bracket screws (SS). The blade
bracket screws (SS) are pre-installed into the blade bracket
(G).
□
Repeat this step for the remaining blade brackets.
2
Attaching the blades to the blade
brackets
□
Mount the fan blade (H) to the blade bracket (G) by align-
ing the three key-slot holes in the blade (H) with the three
posts on the top of the blade bracket (G).
□
Hold the blade (H) with both hands close to the blade
bracket (G) and press the blade (H) down firmly. Ensure
the key-slot holes are properly seated on the blade
bracket (G) posts.
□
While still holding the blade (H) down with both hands,
firmly slide the blade (H) away from the fan-motor (D)
housing until the blade (H) engages in the locking mecha-
nism. Make sure the locking mechanism at the rear of the
blade bracket (G) springs upward and butts against the
edge of the blade (H), indicating a secure connection.
□
Visually inspect the top of the blade bracket (G) to ensure
the locking mechanism is securely in place.
□
Repeat this procedure for the remaining blades (H).
D
SS
G
12
G
H
D