HAMPTON BAY 91469 Guía De Uso Y Cuidado página 8

Assembly - Close-to-Ceiling Mount
1
Preparing for mounting
□
Remove canopy ring (L) from the canopy (C) by turning the
ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (HH) located in the "L
shaped" slots
□
Remove and save the two canopy screws (II) in the round
holes. This will enable you to remove the mounting bracket
(A).
□
Remove the decorative canopy bottom cover (N) from the
canopy (C) by pressing the three studs located inside the
bottom of the canopy.
HH
Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock or
personal injury, mount to outlet box marked "acceptable
for fan support of 35 lbs. (15.9 kg) or less" and use screws
provided with the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Install the ceiling mounting plate on the outlet box by sliding
the mounting bracket (A) over the two screws (KK) provided with
the outlet box. If necessary, use leveling washers (not included)
between the mounting bracket (A) and the outlet box. Note that
the flat side of the mounting bracket (A) is toward the outlet box.
□
Securely tighten the two mounting screws (KK).
2
Routing the wires
□
Remove three of the six screws and lock washers (PP) (every
other one) securing the motor collar to the top of the fan-
motor assembly (D).
□
Route the wires exiting the top of the fan-motor assembly
(D) through the rubber gasket (DD) aligning the holes in the
rubber gasket (DD) with the three screw holes in the fan-
motor assembly (D).
□
Route the wires exiting the top of the fan-motor assembly
(D) through the canopy ring (L), and the canopy (C) (make
sure the slot openings for the canopy ring and canopy are on
top. Place the canopy (C) over the collar (M) at the top of the
motor (D).
□
Align the mounting holes in the canopy (C) with the screw
A
holes in the motor (D) and fasten using the three screws and
lock washers (PP) (removed previously). Tighten the mounting
screws securely.
II
C
N
L
8
PP
L
PP
C
DD
M
D