Lacava ELEGANZA 1810 Manual Del Propietário página 4

Installation Instructions/Instrucciones de Instalación
LACAVA LLC
1. Remove the locking nut and rubber washer from the
mounting post.
2. Unscrew the handle from the vertical pop-up control
rod and then slide the rod through the slot on the back
of the mixer body. Then screw the handle back into
place.
3. Place mixer body with its escutcheon ring and o-ring
still attached through the faucet hole of the mounting
surface.
4. From below the mounting surface slide the rubber
washer and metal washer onto the mounting post
mounting surface.
5. Thread the locking nut onto the mounting post by hand
until tight, and then turn an additional ¼ turn using a
wrench. Be careful not to over-tighten the nut, as this
may cause damage to the mounting surface.
4