Charger And Hand Control; Maintenance/Safety Check - Aquatec ORCA Manual De Instrucciones

1. Wash the product with commercial detergents and
disinfectants using a cloth or brush.
2. Rinse the product with warm water.
3. Dry the product with a cloth.
4. Lightly grease the guide for the sliding shoe (8,
fig. 1) using Vaseline.
5. Unbutton the covers (optional) from the seat and
backrest.
CAUTION!
There is a risk of damage.
Do not tumble-dry the covers.
6. Wash the covers (optional) in the washing ma-
chine at maximum 60 °C using a mild detergent.
7.2

Charger and hand control

CAUTION!
There is a risk of injury from electric shock.
Before cleaning the charger, always pull

the plug out of the power socket.
Never plug objects made of conducting

material (e.g. knitting needles, metal
pins) into the jack socket of the hand
control.
Only use a dry cloth to clean the

charger.
1. Wipe down the charger with a dry cloth.
2. Wipe down the hand control with a damp cloth
and dry it with a dry cloth.
3. If the bathlift will not be used for prolonged
periods, fully charge the battery (charge time of
about 4 hours) and then raise and lower the
bathlift 3 times while it is unloaded. Repeat this
procedure every 12 months. This preserves the
service life of the battery.
16
7.3

Maintenance/safety check

Important!
The hand control may only be opened by the
manufacturer of the lifter.
When used properly, the bathlift is maintenance-free.
Before you use it, check for any visible damage. If you
detect damage, contact an authorised workshop.
To maintain the functional reliability of your bathlift, it
should be inspected by an authorised workshop after
periods of repeated use or after 24 months (refer to the
manufacturer's recommendation for rehabilitation
products from the SPECTARIS industry association).
Only authorised dealers are permitted to perform re-
quired repairs.
EN