Assembling The Trouser Press - Corby 3300 Manual Del Usuario

ASSEMBLING THE TROUSER PRESS

(NOTE: If wall mounting following steps do not apply)
FEET
CORBY 3300/4400/7700
• Place the LONGEST part of the foot at the FRONT of the press.
• Tilt the press to one side and slide the foot onto moulding, a sharp tap with the
hand will click the foot into place.
• Turn the press over and repeat the procedure for the other foot.
CORBY EXECUTIVE/EXECUTIVE +
• Place the LONGEST part of the foot at the REAR of the press. Looking from the REAR
of the press attach foot A to the Left and B to the Right.
• Place the press on its side to bolt the foot to the bottom of the press, making sure
that the washer is between the head of the bolt and the foot.
• Turn the press over and repeat the procedure for the other foot.
HANGER
ALL MODELS Contents: 2 Hanger Screws
NOTE: Alternate hanger bracket on Executive+ uses same fixing method.
• Rest the hanger bracket on the small ledge provided at the rear of the press.
• This will align two of the holes in the bracket with two holes.
• Use the two screws provided to affix the hanger.
• Slide the hanger onto the bracket until it clicks into place.
Contents: 4 Bolts and 4 Washers
1 1