General Specifications - Southwire 41210S Instrucciones De Uso

Introduction
The Southwire 41210S Circuit Breaker Finder identifies the specific
breaker supplying power to an AC outlet or lighting fixture.
The advanced design provides automatic calibration for simple
operation. The GFCI test feature provides a quick method of
checking GFCI outlets. Proper use and care of this instrument
will provide many years of reliable service.
WARNINGS
• Use caution when working on live circuits. Severe shock
hazards exist.
• Do not use in cardiac care areas.
• Only qualified electricians should perform corrective work.
• If used on a circuit controlled by a light dimmer, turn the
dimmer to the highest on position.
• Double check that the correct breaker was turned off before
working on the circuit by using a volt tester or meter.

General Specifications

Operating Voltage
120V AC
Operating Frequency
50 to 60Hz
Battery
9 volt NEDA 1604 or IEC 6LR61 or equivalent
Operating Temperature
41° to 104°F (5° to 40°C)
Operating Humidity
80% max.
Storage Temperature
14° to 140°F (-10° to 60°C)
Storage Humidity
80% max.
Altitude
7000ft ( 2000m) max.
Pollution Degree
II
Safety
Complies with EN61010-1, for use in Overvoltage
CAT III environments
1
Maintenance
This Tester is designed to provide years of dependable service,
if the following care instructions are performed:
1. KEEP THE TESTER DRY. If it gets wet, wipe it off.
2. USE AND STORE THE TESTER IN NORMAL TEMPERATURES. Temperature extremes
can shorten the life of the electronic parts and distort or melt plastic parts.
3. HANDLE THE TESTER GENTLY AND CAREFULLY. Dropping it can damage the
electronic parts or the case.
4. KEEP THE TESTER CLEAN. Wipe the case occasionally with a damp cloth.
DO NOT use chemicals, cleaning solvents, or detergents.
5. USE ONLY FRESH BATTERIES OF THE RECOMMENDED SIZE AND TYPE.
Remove old or weak batteries so they do not leak and damage the unit.
6. IF THE TESTER IS TO BE STORED FOR A LONG PERIOD OF TIME, the batteries
should be removed to prevent damage to the unit.
Tester Description
Receiver
1. Scanning head
2. Red LED indicator
3. Green LED indicator
7.
4. On/Off/Reset button
5. Battery cover
Transmitter
6. LED indicator
7. GFCI test button
6.
1.
2.
3.
4.
5.
2