Princess 282990 Instrucciones De Uso página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
opening in the tap unit. Press on the tap
unit until it clicks into place on the keg.
5 Push the extension pipe firmly onto the
underside of the tap unit.
6 Remove the cover from the appliance.
7 Position the keg with the tap unit in the
appliance.
8 Place the cover on the appliance.
9 Place the grille on the drip tray.
10 Position the drip tray against the
appliance. The drip tray is held in place
by two magnets.
11 Slide the supply voltage selector switch
to the required position: AC or 12 V DC.
• Use AC when you connect the appliance
to the mains supply at home.
• Use 12 V DC when you connect the
appliance to the cigarette lighter socket
in the car or caravan.
12 Connect the AC cable or the 12 V DC
cable to the associated connection on
the appliance.
13 Push the AC cable plug into the wall
socket, or plug the 12 V DC cable plug
into the cigarette lighter socket.
The indicator lamp will light to indicate
that the appliance is switched on.
Tapping
See Figure A-4.
1 Rinse a glass with clean, cold water.
2 Hold the glass at an angle just under
the tap outlet.
3 Open the tap by tilting the tap handle on
the tap unit quickly towards you.
4 Close the tap by pushing the tap on the
tap unit quickly away from you when the
beer reaches the lip of the tilted glass.
5 Place the glass on the drip tray grille.
6 Take the top of the foam off with a
spatula so that the foam head is level
with the top of the glass.
7 Leave the appliance switched on if you
want to keep the keg cooled for a longer
period.
Cooling
See Figure B-1 and C-1.
As well as tapping beer, the Princess Beer
Tap & Cooler is particularly suitable for
keeping products cold. The Princess Beer
Tap & Cooler has the capacity for:
• a maximum of 5 bottles, each with a
content of 75 cl, or
• 17 cans, each with a content of 33 cl, or
• 12 bottles, each with a content of 33 cl
and a diameter of 50 mm.
• Ensure that the products have been
cooled before you place them in the
appliance.
• Before using the appliance, check
whether the mains supply voltage
matches the voltage indicated on the
type plate of the appliance.
1 Remove the cover from the appliance.
2 Slide the sealing block into the opening
in the cover.
3 Slide the supply voltage selector switch
to the required position: AC or 12 V DC.
• Use AC when you connect the appliance
to the mains supply at home.
• Use 12 V DC when you connect the
appliance to the cigarette lighter socket
in the car or caravan.
4 Connect the AC cable or the 12 V DC
cable to the associated connection on
the appliance.
5 Push the AC cable plug into the wall
socket, or plug the 12 V DC cable plug
into the cigarette lighter socket.
The indicator lamp will light to indicate
that the appliance is switched on.
6 Place the pre-cooled products in the
appliance.
7 Place the cover on the appliance.
8 Leave the appliance switched on if you
want to keep the products cooled for a
longer period.
Beer Tap & Cooler Article 282990
7

Publicidad

Tabla de contenido
loading

Tabla de contenido