Beper 40.948 Manual De Instrucciones página 11

Callous remover Use instructions
22. Do not continually rub the unit on the same area or apply strong pressure.
23. Keep the protective cover on your unit when it is not in use.
24. Do not disassemble this device.
Before using your Callous Remover, please read this instruction manual carefully and com-
pletely.
Battery Installation
1. Remove the battery cover (Battery cover lock piece) by
turning it 90 degrees to the left until it clicks into place
(fig. 1) and then pull it down (fig. 2).
2. Insert 2xAA alkaline batteries in the battery compartment
following the battery direction sign (fig. 3) as imprinted on
the back of the unit.
3. Close the battery cover by turning it 90 degrees to the
right (fig. 4) until the cover clicks into place and locks (fig.5).
How to use
This Callous Remover is designed for smoothing coarse skin on the feet and heels ,Do not use this
device anywhere else on the body.
1. Wash and clean the skin and dry fully. Note : Do not use on broken or bleeding skin.
2.Make sure the Rollers Grinding Head is placed into the unit. See section of Changing the rollers
grinding head on how to remove and replace head.
3. Remove the protective cover from the unit and it is ready to Use.
4.Turn on the unit by pressing the safety switch Lock, in the center of the On/Off switch, and at the
same time push the switch up (fig. 6).
5.Gently rotate (back and forth or side to side) (fig.7) the callous/corn/hard skin area for 2-3 secon-
ds. Dot not press hard-gently glide the unit over desire area. The unit will stop if it is press too hard
on the skin. Stop and check if you have achieved the softness you desire. If not, go over the area
for 2-3 more seconds and check again. Continue to use this method until the level of smoothness
is obtained.
Warning: stop using if skin becomes sore or inflamed.
Warning: Do not use on skin for more than 2-3 seconds at a time.
5. Turn the unit off (fig 8).
6. Rinse the skin or use a wet towel to get rid of the excess dead particles.
7. To clean this Callous Remover, please see the Cleaning section.
8. Keep the protective cover on your unit when it is not in use.
11