Beper 40.948 Manual De Instrucciones página 12

Callous remover Use instructions
Changing the rollers Grinding Head
Change the rollers grinding head as needed for best result. the rollers grinding head last for a few
sessions depending on frequency of use and size of area being treated. Replace as needed.
Make sure the unit is turned off before replacing the Rollers Grinding Head.
1. One hand hold the head, another hand press in the release button, on the side of the unit, the
head will tack out (fig. 9&10).
2. Place a new rollers grinding head into the unit until you hear a "click' sound. Be sure to insert the
new head into the unit ,it has been firmly installed. Changing rollers grinding head.
Note: Do not turn your unit On if the rollers grinding head is not attached.
How to Cleaning
Note: Clean the appliance after each use to ensure better performance
This Callous Remover is water resistant It can be rinsed under water for cleaning:
1. Remove the protective cover from the head.
2. Clean the Callous Remover with the cleaning brush. Do not switch the appliance on while brushing
(fig.11).
3. Rinse the unit under the tap. sometime you can operate the unit, keep the head running for 5~10
seconds, that quick and high efficiency (fig.12).
4.Turn the unit off.
5. Wipe the body of the unit with a clean dry cloth.
6. Replace the protective cover.
Storage
When the appliance is not in use, put it on a dry place that children can not touch.
Do not place the appliance in an area with excessive heat or moisture.
12