PNI H1200W Manual De Usuario página 2

Informations
Thank you for buying our product. This user manual is dedicated to power inverters with modified sine wave.
This product is used to transform DC 24V to AC 230V 50Hz/60Hz. We recomend you to read carefully this user
manual before the installation and first use.
1. Do not store / install the product in corrosive, humid, overheated, dusty, mechanical shock or electromagnetic
shock environment.
2. Do not disassembly and do not attempt to repair the product.
3. Keep all documents that come with the product for warranty, and proper maintenance.
Safety measure
To ensure proper operation, the power inverter must be installed by a qualified personnel / electrician and
should be used as specified in this manual.
The inverter uses high temperatures and voltages. We recommend that you carefully read these indications
and contraindications before use, for personal safety and to not damage the product.
Cautions:
We do not assume responsibility for non-compliance with safety measures.
Batteries of different sizes and manufacturers can have different DC voltages.
Ensure that the inverter input voltage corresponds to the battery voltage.
Contact the manufacturer for more details.
Any change in configuration, system structure may affect performance.
DANGER! HIGH VOLTAGE!
Touching the device with your hands wet or wet objects could put you in danger.
1. Do not disassembly the product. Input and output of the inverter are subject to high voltage hazards.
Disassembly and touching the product can put you in high danger.
2. Before the maintenance, disconnect the inverter power completely.
It is recommended to check with a voltmeter both the input and the output to ensure it is disconnected.
3. Even if the power supply is disconnected completely, there may be residual energy in the inverter. Leave the
inverter disconnected for 10 minutes to ensure that the system is fully discharged.
4. Keep the inverter packed before installation and use.
5. Do not operate the inverter in the presence of electric conductors: metal watch, bracelets, rings.
6. The inverter must only be fixed, installed and maintained by qualified personnel.
Attention to inductive loads and half-wave rectifying
We recommend you to choose an inverter with a power of 2-3 times bigger than the power of the inductive
consumer, or half-wave modified.
Avoid static danger
We recommend wearing a ground-mounted antistatic bracelet to protect sensitive parts of static discharge
equipment.
Do not unplug / disconnect the product connected to the power and turned on
Do not install or disconnect the appliance while it is on. Pay close attention to connecting power wires.
Use only regulated batteries
Use only regulated batteries. Using unregulated batteries may cause the product to become malfunctioning.
INTRODUCTION
3
EN