Using The Heater - Gabarron TVC-1500 Instrucciones De Instalacion Y Uso

EN

2.- USING THE HEATER

Check the safe condition of the device before using.
•
The device is in good conditions and there are no visible defects.
•
All parts of the device are firmly attached.
•
The power switch of the device is in OFF position before plugging the heater to the power supply.
Switching on the Heater
Set heating power switch and temperature control thermostat as follows:
Heating Power
Set the heating power rotary switch to the desired position:
•
Rotary switch on []: Lower heating power (750W)
•
Rotary switch on []: Higher heating power (1500 W)
Temperature Control
Set the rotary switch to a position between MIN and MAX:
•
Rotary switch to the left (MIN): Lower room temperature
•
Rotary switch to the right (MAX): Higher room temperature
When the desired temperature has been reached, the blower shuts off automatically. To increase the room temperature, turn
the rotary regulator further to the right.
Ventilation without heat
•
Turn temperature control thermostat to the right
•
Set heating power switch to [].
•
The device ventilates with unheated air.
Switching off
Set heating power switch to [OFF] position.
Note: The device is supplied with a tip-over switch. In case the appliance falls dawn, the tip-over switch will turn off the heater
automatically.
Heating Power Switch
Temperature Control Thermostat
5