Using The Heater - Gabarron CP-2000 Instrucciones De Instalacion Y Uso

EN
2.- COMPONENTS AND ASSEMBLY
Thermostat Switch
Feet Assembly
Carefully remove the heater from the plastic bag and carton.
Attach the two plastic feet to the bottom of the appliance with the 2 delivered screws.
Step 1: Put the feet into the right position
Place the heater on a firm and level surface.

3.- USING THE HEATER

Power Switch
Set the thermostat switch to maximum, and operate the appliance until the desired room temperature is reached. Then, turn
the themostat switch until the appliance switches off with an audible "click". This set temperature will be kept almost constant
by the appliance switching on and off automatically. Please note that the appliance does not switch on unless the thermostat
setting is higher than the room temperature.
Air Grille Outlet
Power Switch
Feet
Thermostat Switch
Step 2: Fix the feet with screws.
Warning the heater must not be operated without the
feet assembled
- Plug the power cord into a 220-240V~
electrical outlet.
- Press the power switch to 750W or
1250W depending on the required power, or
press both (750W + 1250W at the same time
Indicator Light
for 2000W power. The indicator light will be
on.
5
Front Cover