Transport And Storage - Saci 6 Manual De Instrucciones De Montaje Y Servicio

2-3 General Safety Instructions:
The following general safety rules should be read before starting the motor:
- Use only the motor under the water (the motor and motor cable should be completely
submerged)
- Do not make any change to the motor or the electrical connections
- Never open the motor
- Never use the motor with a damaged pump
- Repair or connect only when the motor stopped.
- Disconnect the motor tension during all work, make sure that no one can inadvertently
reconnect the power while working on the engine
- Never work on electrical installations during a storm
- Before starting the engine check that all electrical connections and devices have been safety
reviewed and that all fuses and protections have been set correctly
- Ensure that there's no access to any hazardous area, electrical parts, rotating parts and suction
areas
- The repair must be performed by qualified personnel in a workshop. Use original spare parts
only.
3 Transport , Storage and Disposal
3-1 Storage
- The engine must be kept in their original packaging until installation. If the engine is stored
vertically, make sure you can't tip over. Always keep the shaft up. Do not store motor under direct
sunlight or other heat sources
- Keep storage temperature (between -15 º C to +60 º C)
3-2 Transport
The fall of the load may cause death or crushed limbs
WARNING
- No person shall remain for no reason under the suspended load
- Use only lifting and loading machines suitable for this type of work
- Place the attachment point at the center of gravity of the load
3-3 Unpacking
- Avoid any shock or impact on the motor. Be careful when opening the packaging to avoid
damaging the cable. After unpacking the motor make sure there is no harm in housing, shaft, or
cable
- If you observe any anomalies immediately inform the supplier
Risk of death from electric shock if the cable is damaged
Do not install or operate motor if you notice that the cable is damaged
WARNING
3-4 Disposal
- To avoid damaging the environment, remove the packing in an appropriate manner to avoid
damaging the environment and prevent pollution caused by detergents, lubricants etc.
- Take into account local environment laws.