Astralpool EF Serie Manual Tecnico página 40

MODEL
EF-4
EF-6
EF-8
EF-10
EF-12
EF-15
EF-17
Regulator and ON / OFF switch are placed inside the cooler with axial fan; for access front cover
of the equipment must be removed.
The electrical installation should be done by qualified professionals, keeping in mind the following
points:
• Perform electrical connections following present manual indications.
• Place a U-curve thermal-magnetic circuit breaker in the general power connection to protect
the line in case of a short in the circuit.
• Place a differential circuit breaker in the general power connection to protect the equipment
from possible ground problems. The differential breaker should be minimum 30mA.
• Before installing the connections are sure to disconnect the electricity so that the power supply
is turned off.
• Connect the power supply wires to the machines input terminals.
• Connect the grounding wire to its corresponding terminal.
IMPORTANT
Cooler Air-Water EF shall never operate without the simultaneous
:
operation of the purifier pump. Special careful should be taken at the time of interconnecting
timers or programmers that may stop the purification pump, leaving the cooler running.
• All local and national electric regulations concerning protection against defects in electric
power lines should be respected at all times during installation.
• Verify the torque of all electrical connections.
• The electrical resistance between ground and any electrical terminal will be verified to be
greater than 1 megaohm, if less, equipment shall not be powered on until power loss is located and
repaired.
© TALLERES DEL AGUA S.L. 2008. TODOS LOS DERECHOS RESERVADOS. DOCUMENTO CONFIDENCIAL Y EN PROPIEDAD.
VOLTAGE (V)
220 II
380 III
GENERAL POWER
2
SECTION (mm )
40 mts. max.
ALASKA SIBERIA
2,5
4
2,5
2,5
REGULATOR
ON / OFF SWITCH
ENGLISH
Nº OF WIRES
2 + GROUND
4 + GROUND
Page 40 of 50