HoMedics Shiatsu AntiGravity Recliner AG-3000 Manual De Instrucciones página 3

AG-3000-A 5/13/04 10:35 AM Page 5
Components
Carefully remove all contents from packaging and inspect the product
to make sure all components of the chair have been received. These should include:
• Left armrest A
• Right armrest with control panel B
• Front cross bar C
• Bottom cross bar D
• Back frame with attached cushion and massage mechanism E
• Seat frame with attached cushion F
• Large bolts and bolt sleeves for crossbars (8) G
• Small bolts for back and seat frames (8) H
• Small Allen wrenches I
• Optional softening pad J
• Detachable headrest K
• AC adaptor L
See Figure 1.
Figure 1
B
8
6
2
4
4
2
6
F
L
K
E
8
Output
Jack
7
3
D
1
C
A
Input
Jack
5
1
3 I
H
G
4
Easy to Follow Guide to Chair Assembly
1. Assemble Chair Base
• Attach the front cross bar C
the left armrest. Secure with the provided large bolts and bolt sleeves
bottom cross bar D to the left armrest ensuring the labeled "3" on the crossbar lines up with the "3" on the
armrest. Secure with the provided large bolts and bolt sleeves using the allen wrench.
DO NOT FULLY TIGHTEN BO LTS AT THIS POINT. See Figure 2.
• Attach right armrest B to cross bars C
with the "2" and "4" on the armrest. Secure with large bolts and bolt sleeves using the allen wrench.
See Figure 3.
• Tighten all bolts, ensuring the base sits level without wobbling.
NOTE: ASSEMBLE BASE ON ITS SIDE.
C
D
A
2. Attach Seat Cushion/Frame to Base
• Align the holes on the bottom of the seat frame
secure the seat frame to the base frame. Bolts must be inserted from the underside of the chair. See Figure 4.
• Tighten all bolts evenly using the allen wrench.
J
NOTE: IT MAY BE EASIER TO TURN THE BASE ON ITS SIDE TO INSERT THE BO LT S .
3. Attach Back Cushion/Frame to Base
• Align the holes at the bottom of the back frame E with the holes in the lower bracket in the base frame. Use
small bolts to secure the back frame to the base frame. See Figure 5. Attached correctly, the back frame will form
a concave shape and fabric stitching should face up. See Figure 6.
• Tighten all bolts evenly using the allen wrench provided.
E
to left armrest A by lining up the labeled "1" on the cross bar with the "1" on
G using the allen wrench
D making sure to line up the labeled "2" and "4" on the cross bars
B
C
D
A
Figure 2
Figure 3
F with the holes in the base frame. Use small bolts
F
Figure 4
Figure 5
5
I . Attach the
H t o
Figure 6