Incoming Plumbing Elevation; Specification List For Installation Detail Drawings Above - Hunter STK-1 Instrucciones De Instalación

INSTallaTIoN INSTruCTIoNS for huNTEr STK-2
upper surface that surrounds the enclosure's covers once they are
installed. The quick coupler inlet piping needs to be 5" from the
inner rim of the enclosure at the top and 5" from the inner rim of
the enclosure on the right side (#24).
"OFF FIELD SIDE"
"ON FIELD SIDE"

Incoming Plumbing Elevation

The swing joint's inlet piping location and depth is critical. This
location and depth in conjunction with the special multi-axis vertical
alignment "VA" swing joint allows the rotor to be placed and
leveled within the hole in the enclosure's cover. Use the Side View
of the following installation detail as a reference. Note that the VA
swing joint's first horizontal section is resting at a level that is at the
same level as the bottom of the enclosure (#22). This depth is 26"
from the top of the enclosure.
16
The quick coupler inlet piping (#13) must align with the quick
coupler access hole in the enclosure's cover (#24). Also, in order
for the quick coupler key with its handle attached to operate the
quick coupler valve, the quick valve must be installed as close to
the underside of the main cover as possible. Use the Side View
illustration shown below as a reference. The quick coupler must be
installed so that the final elevation is approximately ½" below the
underside of the main enclosure cover (#20).
"VIEW FROM ON FIELD SIDE"

Specification list for Installation Detail Drawings above

1. Hunter ST173026B* composite box and 2-piece polymer-
concrete lid assembly with cast-in opening to support rotor
lateral thrust plus cast in opening with circular cover for quick
coupler access
ENG