Hotpoint SXBHAE 924 WD Instrucciones De Uso página 10

Leveling door
1. Precautions before installation:
Before installation of accessories, it shall be ensured that the refrigerator is disconnected from
power.
Before adjusting the , precautions shall be taken to prevent a door ny personal injury.
2. Schematic diagram of leveling the door
List of tools to be provided by the user
The actual configuration will depend on the physical product or statement by the distributo
When the fridge door is low:
Open the door, use a wrench to loosen the locking nut and to rotate the adjusting nut anti-clockwise
to raise the height of the door. Once the doors are aligned, then tighten the locking nut by rotating it
anti-clockwise.
When the fridge door is high:
Open the door, use a wrench to rotate the adjusting nut clockwise to lower the height of the door.
Once the doors are aligned, then tighten the locking nutby rotating it anti-clockwise.
Connection of the Water Facility
1. Precautions before installation:
Information in the Instruction Manual is only for reference. The physical product may differ.
Before installation of accessories, it shall be ensured that the refrigerator is disconnected from
power.
Water hazards!
The water pressure of the combined fridge-freezer is 2-7 bars. If the water pressure is too high,
please install a decompressor.
Please do not connect combined fridge-freezers to a tap or a tap of water heater.
Please do not bend inlet pipes and drain-pipes when placing, and shall carefully connect water pipes.
Do not use any old and used water pipes.
Please purchase the joint to connect the pipe and the faucet and install it according to the schematic
diagram.
wrench
Fixed shaft
Leveling feet
Loocking nut
The picture above is only for reference.
9
Adjusting nut
Wrench