Cleaning And Maintenance; Disposal Of Packaging Materials - Hotpoint SXBHAE 924 WD Instrucciones De Uso

appliance must be disconnected
from the power supply before any
installation operation - risk of electric
shock. During installation, make sure
the appliance does not damage the
power cable - risk of fire or electric
shock. Only activate the appliance
when the installation has been
completed.
Be careful not to damage the
floors (e.g. parquet) when moving
the appliance. Install the appliance
on a floor or support strong enough
to take its weight and in a place
suitable for its size and use. Make
sure the appliance is not near a
heat source and that the four feet
are stable and resting on the floo ,
adjust as required, and check that
the appliance is perfectly level using
a spirit level. Wait at least two hours
before switching the appliance on, to
ensure that the refrigerant circuit is
fully efficient
WARNING: To avoid a hazard
due to instability, positioning or fixing
of the appliance must be done in
accordance with the manufacturer
instructions. It is forbidden to place
the refrigerator in such way that the
metal hose of gas stove, metal gas or
water pipes, or electrical wires are
in contact with the refrigerator back
wall (condenser coil).
All dimensions and spacing needed
for installation of the appliance are in
the Installation instruction booklet.
ELECTRICAL WARNINGS
It must be possible to disconnect
the appliance from the power
supply by unplugging it if plug is
accessible, or by a multi-pole switch
installed upstream of the socket in
accordance with the wiring rules
and the appliance must be earthed
in conformity with national electrical
safety standards.
Do not use extension leads,
multiple sockets or adapters. The
electrical components must not
be accessible to the user after
installation. Do not use the appliance
when you are wet or barefoot. Do
not operate this appliance if it has a
damaged power cable or plug, if it
is not working properly, or if it has
been damaged or dropped.
If the supply cord is damaged, it
must be replaced with an identical
one by the manufacturer, its service
agent or similarly qualified persons
in order to avoid a hazard - risk of
electric shock.
CLEANING AND
MAINTENANCE
WARNING: Ensure that the
appliance is switched off and
disconnected from the power supply
before performing any maintenance
operation; never use steam cleaning
equipment - risk of electric shock.
Do not use abrasive or harsh
cleaners such as window sprays,
scouring cleansers, flammable
fluids, cleaning waxes, concentrated
detergents, bleaches or cleansers
containing petroleum products
on plastic parts, interior and door
liners or gaskets. Do not use paper
towels, scouring pads, or other harsh
cleaning tools.
DISPOSAL OF PACKAGING
MATERIALS
The packaging material is 100% recyclable and is
marked with the recycle symbol
6
.