Clatronic BFS 2357 Instrucciones De Servicio página 20

25158-05-BFS 2357
GB
Run the unit once without any bottles in it.
Clean all the parts in a rinsing bath. Wipe down the case with a cloth.
1. Place the unit on a level surface.
2. Pour 90 - 100 ml water into the unit.
3. Place the bottle holder in the unit.
4. Place the bottles inside, upside down.
5. Remove the cover and place the teats and the bottle seals with the opening
pointing downwards so that each seal is above two bottles.
6. Put the cover on.
7. Turn on the unit at the ON switch. The indicator light comes on. The unit swit-
ches itself off automatically after the operating time of approx. 15 minutes. The
indicator light goes out. The operating time changes according to the amount of
water that was put in and the number of bottles.
Switch off the unit after use and pull the plug out of the mains socket.
COMMENTS:
• The bottles and the seals should not touch each other.
• You can turn the cover to match the size of the bottle.
• Pull the plug out of the mains socket before cleaning the unit.
• Only use a damp cloth to clean the unit. Never put the unit into water.
• Do not use aggressive or foaming cleaners.
• Wipe off any remaining water with a clean cloth.
The decalcification intervals depend on the hardness of the water and the frequen-
cy of use. Decalcification should be carried out every 3 to 4 months.
If the machine switches off before the water boils, it probably needs to be decalci-
fied.
Please do not use vinegar but a commercially available decalcification agent on the
basis of citric acid. Only use the quantities stated in the instructions.
This appliance conforms with the CE directives for radio interference suppression
and low-voltage safety and has been built to meet current safety requirements.
Subject to technical changes without prior notice!
20
14.08.2003 9:22 Uhr
Using the unit for the first time
Cleaning
Decalcification
Seite 20
Use