Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Water Connection
The high-pressure cleaner is suitable for connection to a standard domestic water
supply. Please observe the regulations of your water supply company.
The supply hose (not supplied) should have the following dimensions:
Length:
For the connection values please see the technical data contained in these
instructions.
Use
•
The device is intended for private use only.
•
Clean machines, vehicles, buildings, tools, facades, terraces, garden tools etc.
with the high-pressure water jet. If necessary you can also use detergents.
Please use detergents sparingly, noting the quantities recommended by the
producer.
Please note:
•
The cleaning of motors/engines and other surfaces that may be covered with
oil is only allowed in conjunction with an appropriate oil separator.
•
Do not clean any surfaces that may contain hazardous materials, such as
asbestos.
Water
•
If necessary, clean the supply water with a water fi lter. Any impurities in the
water could damage the pump.
•
Operating the high-pressure cleaner without water will damage the pump. Ple-
ase ensure before switching on the cleaner that the water supply is available.
Bleeding the Device before Use.
•
The device must be connected to the electricity and water supply (See „Con-
nection", points 1-4 in the section „Operation").
•
Unscrew the high-pressure hose (7) from the high-pressure connection (2) of
the device.
•
Switch on the device and allow it to run until the water coming out of the high-
pressure connection no longer contains any bubbles.
•
Switch off the machine at the main switch (1) and screw the high-pressure
hose (7) back on.
Cleaning Method
1. Spray the detergent sparingly on to the dry surface. Allow it to act for a short
time without letting the detergent dry.
6....-05-HDR 2941 63
min 7,5 m
Instructions for use
Diameter:
min. 1/2"
07.01.2005, 14:32:17 Uhr
GB
63
Publicidad
Tabla de contenido
