Clatronic HDR 2941 Instrucciones De Servicio página 64

2. Rinse off the loosened dirt with the high-pressure jet.
GB
Water Loss
It is normal for the pump to lose small quantities of water. If there is a sizeable
leak, please contact our service department.
Protection against Damage
Please do not underestimate the pressure produced by the high-pressure
cleaner. If you would like to clean sensitive surfaces it is better to use the fan
jet (See „Adjustment of the Spray Jet" in the section „Operation"). In the case of
paints or insulated facades please begin at a considerable distance away. Move
slowly closer - depending on the degree of soiling - to the object to be cleaned.
Check the progress of your work at short intervals in order to prevent damage.
Never point the high-pressure jet at other people, animals, the device itself
or electrical equipment!
Connection
1. Use a hose to connect the water connection (3) to the water supply.
2. Open the water supply and check for any leaks. A low level of water loss by the
pump is normal.
3. Secure the manual spray gun (8) with the lock (10).
4. Insert the mains plug (9).
5. Turn the main switch (1) on.
Working with the Hand Spray Gun (8)
Switching on:
Switching off:
Adjustment of the Spray Jet
By turning the nozzle (5) you can vary the spray from a narrow jet to a fan jet. See
also ABB. 1.
Note: If you use the detergent vessel, the spray jet should only be adjusted when
the device is not in operation. Otherwise there is a danger that the detergent ves-
sel will become loose when the spray jet is adjusted (danger of injury). Please also
ensure that the detergent vessel is always facing downwards and is fi rmly in place
on the high-pressure nozzle (11) before putting the device into operation.
64
6....-05-HDR 2941 64
Operation
Release the lock (10) and pull the lever of the gun.
Caution! Recoil
Release the lever. During work breaks secure the hand spray
gun (8) with the lock (10).
07.01.2005, 14:32:17 Uhr