BTV ROUND KABILA Manual De Instrucciones página 8

• Remove the door prior to installation to avoid damaging the lock system and to
allow the telescopic system to be set correctly.
Construction job
• The aperture prepared for the safe must be at least 10cms wider all round than
the box. Its depends on the strength of the installation works.
• Dampen the hole created for the safe.
EN
• Use the bag that the safe came in to protect it, both inside and outside, during
the installation process.
•Insert the safe into the prepared hole and check the position.
• Adjust the depth of the safe by unscrewing/screwing the adjustable body (4) to
fit the wall. Remember to allow enough space for the mortar behind the safe.
• Once the depth has been adjusted correctly position the safe in the hole and
check the level, both vertically and horizontally.
• Prepare a 3 of sand to 1 of cement mortar mix (we do not recommend using
quick-dry cement). Carefully fill the hole around the safe, ensuring the safe is
completely embedded in the mortar. Make sure the front surface of the product is
adequately protected during the installation process.
• Once the hole is filled with mortar and the safe is installed, remove the plastic
protective bag and make good the exterior surface.
• Leave the safe open until the mortar is completely dry. This is to avoid any
condensation forming inside it.
• Use the safe only when the work is completely dry
8