ESX SUB-D300 Manual De Instrucciones página 9

INSTALLATION AND SUBWOOFER CONNECTION
Use the enclosed cutting template to mill or saw the amplifier module mounting hole into the subwoofer enclo-
sure. Before screwing the amplifier module firmly, connect the subwoofer as follows:
RED +
BLACK –
POWER SUPPLY AND TURN-ON-CONNECTION
ATTENTION: Before you start with the installation, disconnect the ground connection from the ve-
hicle's battery in order to prevent short circuits.
The power wiring which is usually installed in on-board car networks is not sufficient for a power amplifier's
demands. Make sure that the power wires to GND and to the +12 V terminal has been sufficiently specified.
First connect the GND terminal [ 6 ] of the amplifier to an appropriate ground connection at the chassis. To
ensure a good connection, residue dirt and dust from the connection point. A loose connection may cause
malfunctions or interferences noise and distortion.
Then connect the +12 V terminal [ 4 ] of the amplifier with the battery by using an appropriate cable including
an in-line fuse. This fuse [ 2 ] should be located very close to the battery [ 1 ]; for safety reasons not more than
30 cm away. Only insert the fuse when the installation, including the connection of the loudspeakers, has been
accomplished.
Then connect the remote turn-on-wire [ 3 ] from the head unit with the amplifier's REM terminal [ 5 ]. A cable
with a cross-section of 0.5 mm
1
–
is adequate.
2
2
45 x 14 mm
V800A
ACTIVE SUBWOOFER SYSTEM
HIGH EFFICIENCY DIGITAL AMPLIFIER
RECOMMENDED POWER
CAPACITY FOR THE SUBWOOFER:
2 Ohm operation: 300-350 Watts RMS
4 Ohm operation: 200-250 Watts RMS
–
+
NOTE: The amplifier module is
not designed for 1 Ohm operation.
3
SUB – D300
ACTIVE SUBWOOFER SYSTEM
HIGH EFFICIENCY DIGITAL AMPLIFIER
HI LEVEL INPUT REMOTE
L R
–
L R
+
LINE INPUT
L
PHASE
SHIFT
0° OFF
180° ON
LEVEL
MIN MAX
BASS BOOST
0dB 12dB
LOW PASS
50Hz 150Hz
CROSSOVER SLOPE
12dB 18dB
PROTECT POWER
FUSE
4 5 6
+12V REM GND
45 x 14 mm
R
AUTO
TURN ON
9