Aqua Medic DC Runner x.3 Serie Manual De Instrucciones página 9

Fig. 3: Reset password
3. Add a pump to a network
Click on "Add" in the lower left corner of the APP and on the following page select the device type to be added.
In case of a circulation pump of the DC Runner x.3 series, choose the pump symbol "Pump".
Configuration mode: Make sure your phone is connected to 2.4 G band WiFi before configuration. It
doesn't work in the 5 G band WiFi.
There are two types of configuration modes: Smart configuration and AP configuration modes. Choose the
„Smart Configuration Mode" to link your device. The AP-mode is not available at the moment.
Fig. 4: The desired mode is confirmed by tapping on the circle above the lower arrow. By tapping on "AP
Network" or "Smart Network" next to the upper arrow (the arrow is not available in the APP), you can switch
between the two modes. (The "Smart Configuration Mode" must be selected here. The green and red LEDs only
flash in the case of dosing pumps; in the case of pumps, the blue WiFi symbol flashes in the controller).
3.1. Smart configuration (WiFi-mode)
This is the mode for pump control via WiFi. Press the WIFI button for about 5 seconds and the WIFI indicator
flashes. The device is in WiFi configuration mode.
When the WIFI symbol flashes in the upper right corner of the pump controller, tap "Device is in smart
configuration mode" and click "NEXT". Positioning must be switched on in the settings of the smartphone
used. Follow the instructions. Check that the network name is correct (if not, the smartphone is in the wrong
network), then enter the correct WiFi password and tap "NEXT".
Make sure your pump, phone, and router are as close together as possible during the configuration process.
9