Qid Tower Battery Charging And Installation; Qid Tower Setup - QIMMIQ QID Tower Manual Del Usuario

QID TOWER Battery Charging and Installation

1. Take the battery out of the QID TOWER by sliding the black button down to remove the battery casing and disconnecting
the battery from the socket.
2. Connect the battery to the USB cable and plug the cable into a USB port. The light will turn on when charging and turn off
when it is fully charged.
3. Re-connect the battery to the drone and replace the battery well cover until it is locked back into place.
Warning
1. After flying, please do not charge the battery if the surface temperature is still not cool. Otherwise, it may cause a
deformed battery or even a fire hazard.
2. Please make sure that you use the original adapter provided with the drone and when the battery has been used for a
long time, or appears to be deformed, please replace them.
3. If not in use for a long time, it will lose its charge. Charging or discharging too often may reduce its usable lifespan.

QID TOWER Setup

1. Foldable structure
Propeller arms can be pulled up and out from the QID TOWER body and locked into place. To fold them up, slide the black
button to unlock them and push back to the side of the QID TOWER.
2. Drone propellers
Attach propellers by screwing on with the screwdriver provided. Ensure that new propellers are installed in the same
direction.
3. Propeller guards
Insert the narrow end of the guard into the hole on the underside of the propeller arm. Firmly attach with screws provided
through the small holes as indicated.
32