Mr Coffee Home Café SingleServe AT13 Manual Del Usuario página 5

5. When the unit stops, empty the mug and return it to the brewing plate.
6. Press the 9 oz. Brew Button again. Empty the mug and return it to the
brewing plate.
7. Fill the water reservoir up to slightly below the MAX line with fresh, cold water.
8. Press the 14 oz. Brew Button to flush out the remaining solution. Empty the
mug and return it to the brewing plate. Repeat the process until the water
reservoir is empty.
9. Wash the Brew Basket as instructed in the Regular Cleaning Section.
T R O U B L E S H O O T I N G Y O U R
H O M E C A F É ® C O F F E E M A K E R
Your Home Café Coffeemaker has been carefully designed to give you many years
®
of trouble-free service. In the unlikely event that your coffeemaker does not operate
satisfactorily, please review the following potential problems and try the steps
recommended BEFORE you call an Authorized Sunbeam Service Center.
PROBLEM POSSIBLE CAUSE
Not Brewing The appliance is unplugged.
Appliance has not been primed Allow to cool until red indicator
There's a power outage.
The water reservoir is empty
or is not properly seated.
The lid is not in the closed
position.
The pod holder is not
properly inserted.
Dispensing Pod and/or pod holder
only water not in place.
Not Brewing The unit is out of water.
enough coffee If the unit runs out of water,
it will automatically stop
Coffee not Used a mild roast pod.
strong enough
Too large cup size selected.
Coffee was brewed without
pod holder in place.
Used same pod twice.
7
SOLUTION
Plug unit in.
light comes back on and then
prime the unit as per "Preparing
your Coffeemaker Before First
Use" Instructions on page 4
Wait for power to be restored.
Red stop indicator light blinks.
Push the Stop button, refill water
reservoir and begin new brew
using new pod.
The red Stop indicator light blinks.
Press the Stop Button. Firmly close
the lid before selecting a brew
button.
Insert Pod Holder correctly.
Make sure that the Pod Holder is
in place.
Refill the Water Reservoir. Start
with a fresh cup and coffee
pod and brew your next cup.
Use either two mild blend pods for
7 oz. or 9 oz. drink or try a
dark roast pod.
Try using a smaller cup size
selection.
Make sure that the Pod Holder is
in place.
Discard used pod. Place new pod
with flat side up.
T R O U B L E S H O O T I N G Y O U R
H O M E C A F É C O F F E E M A K E R ( c o n t i n u e d )
®
PROBLEM POSSIBLE CAUSE
Coffee taste The pod(s) may not have
been placedin the pod holder
with flat side up.
Damaged pod or regular
ground coffee used.
Water reservoir filled with
unfiltered water.
Grounds Damaged pod or regular
in coffee ground coffee used.
Leaking The Water reservoir is not
properly placed.
Mineral deposits have built up
in the unit.
Pods inserted incorrectly
or using the wrong pod holder. # of pods being used, insert pods
Dripping Brew Basket/Pod holder got
clogged up.
Overflowing The pod holder is clogged or
too many pods in the pod .
holder
Unit noisy Pump in engaged.
Water Reservoir is empty.
Red Stop Light Water Reservoir is empty or
not properly seated
The lid is open
The pod holder is clogged
SOLUTION
Discard used pod. Place new pod
with flat side up.
Do not use damaged or torn pods.
Use only Folgers ® and Millstone ®
pods. Do not use ground coffee.
Use filtered water for better tasting
coffee.
Use only Do not use damaged
or torn pods. Folgers and
®
Millstone ® pods. Do not use
ground coffee.
Secure the Water Reservoir in
place.
Follow the "Decalcifying your
Coffeemaker" instructions.
Use the correct pod holder for the
flat side up and properly placed
in the pod holder.
Clean the Brew Basket and Pod
holder.
Red Stop indicator light blinks.
Press the Stop Button, allow the
coffeemaker to cool down,
replace pod with new one and
resume brewing.
The noise you hear is part of the
normal function and operation of
the coffeemaker.
Red Stop indicator light blinks. Press
Stop Button and fill the water reser-
voir with water. Turn the unit on by
making your cup size selection.
Red Stop indicator light blinks.
Press the Stop Button and seat
the reservoir properly, refill water
reservoir and begin new brew
using new pod.
Red Stop indicator light blinks.
Press Stop Button. Firmly close the lid
before selecting a brew button.
Red indicator light blinks.
Press Stop Button. Allow the unit to
cool down, clean the pod holder
and start brewing with a new pod.
8