Kenmore 8000 BTU Manual De Uso Y Cuidado página 10

6 Mode Selection Button – Press Mode key to switch between modes. With each
press, the mode indicator will light up in sequence from Cool ---> Dehum ---> Fan
7 Power Key – Press the key to turn unit operation on or off. With key off the
display shows surrounding air temperature.
Remote Control
Point the remote control at the unit control panel when pressing remote control keys.
You will hear the unit beep to confirm remote control key activation.
Protective Functions
Frost Protection – In Cool and Dry modes, if the temperature of the compressor
becomes too low, the unit will automatically enter protection status. Once coil rises
to a sufficient temperature, the unit will automatically revert to normal operation.
Overflow Protection – When water in the water pan exceeds the maximum level,
the unit will beep, stop running, and the display screen will show FL. The water in
the pan must be drained empty before the unit will resume operation. See the
Drainage Instructions in the next section of this Use & Care Guide.
Automatic Defrosting – The air conditioner has automatic defrosting. During
defrosting, the compressor will stop working for about 3-5 minutes, during which
time the fan continues to run.
Automatic Thermal Protection – The air conditioner has automatic thermal
protection to protect against overheating. When thermal protection is activated,
the compressor and motor will stop. Once cooled to a safe operation temperature,
the unit can be restarted.
Page 10
CONTROL SETTINGS
1 Power – Press
2 Timer – Press TIMER key to set the timer.
3 Sleep – Press SLEEP key to turn on sleep mode.
4 Down – Press
adjust timer setting.
5 Up – Press
timer setting.
6 Mode – Press MODE key to switch between cooling,
dehumidifying and fan-only mode.
7 Fan – Press FAN key to select high or low wind speed.
8 Temperature unit converter – ⁰F
key to turn unit operation on and off.
key to reduce temperature and
key to increase the temperature and adjust
⁰C