Specifications
System Specifications:
Channels
Frequency Type
Modulation Type
Noise Reduction Type
Distance
Transmitter (UH1, UT1L, UT1G):
Oscillation Type
Pre-emphasis
Antenna
UH1
UT1L / UT1G
Input (UT1L)
Maximum Input Level
Battery
Operating Temperature
Switches / Controls
UH1
UT1L / UT1G
Display (LED)
Operating Voltage
Current Consumption
RF Power
Frequency Stability
Spurious Ratio
Deviation
T.H.D. (Overall)
AF Frequency Response
Battery life
Receiver (UR1):
Oscillation Type
De-emphasis
IF Frequency
Antenna
In/Out
Display (LED)
Level Control
Operating Temperature
Operating Voltage
Current Consumption
Receiving Frequency Range
Sensitivity
Squelch Sensitivity
Selectivity
T.H.D. (Overall)
S/N Ratio (Overall)
Residual Noise
Band Mute
AF Frequency Response
Audio Output Level - Unbalanced
Audio Output Level - Balanced
Audio Output Impedance - Unbalanced
Audio Output Impedance - Balanced
Battery Low/Mid/High (corresponds to <5.3 V / 5.3 - 7 V / >7V)
Receiver A/B (Green), Power On (Red), Peak (Yellow), RF Level (5 pc)
44
1/4 Wave Length Wire (Pig Tail)
TB3M Switchcraft Connector
Duracell MN1604 9-volt alkaline
Power ON/OFF, Audio ON/OFF
20 kHz (16.5 kHz - 23.5 kHz)
0.5% (3% max) (@AF 1 kHz, RF 46 dBu)
50 Hz - 15 kHz (±3 dB overall)
DC Inlet, Balanced Output, Unbalanced Output
Audio Level Volume, Mute Level Control
±150 kHz (AF Out Ratio -60 dB)
1% Max (@AF 1 kHz, RF 46 dBu)
±40 kHz / ±100 kHz (RF IN: 46 dBu EMF)
50 Hz - 15 kHz (±3 dB overall)
-20 dBm (Line), -40 dBm (Mic)
Compander/Expander
300 feet
Direct PLL
50 µsec
Integral Antenna
3 V p-p
-20° C / 55° C
Mic Level Volume
Audio Level
9 Volts +20% / -40%
47 mA
10 mW
±20 kHz
2.5 nW
12 hours
Crystal Controlled
50 µsec
10.7 MHz
1/4 Wavelength Rod
0° C / 50° C
12 Volts ±10%
170 mA (at all LED lights)
801 - 805 MHz
18 dBµ (@ THD 2%)
0 - 40 dBµ (Adjustable)
90 dB (w/IHF-A Filter)
90 dBv (w/IHF-A Filter)
0 dBv
5 k Ohms
600 Ohms
6
F3
FM