Using The Enhancer - Samson S-com 4 Manual Del Propietário

Operating The S•com 4

USING THE ENHANCER

The S•com 4's ENHANCER switch can be engaged to activate the EFR (Enhanced Frequency Recovery) circuit.
By engaging the ENHANCER, the S•com 4 EFR restores the high frequency content that can be lost when high
gain reduction is applied. The S•com 4 EFR achieves this by adding back the high-end of the original signal in an
amount that is equal to the amount of gain reduction.
EXPANDER/GATE
TRIGGER
4 CHANNEL 20
COMPRESSOR
GATE
GATE
50 0
OFF +10
dB
RELEASE
• Follow the section above, "SETTING UP THE S•com 4" for normalizing the controls and run a signal such
as a CD through the S•com 4.
• Press the In/Out switch (located between Channels 1 and 2) to the IN position.
• Adjust the Ratio to 6 - 8:1.
• Switch on the ENHANCER and listen to how the high end is restored when the ENHANCER is on.
GAIN REDUCTION dB INPUT / OUTPUT LEVEL dB
-24 -12 -6 -4 -2 -18 -6 0 +6
COMPRESSOR / LIMITER CH 1
THRESHOLD RATIO METER OUTPUT
-10 4:1 0
I/O
-30 10 2 6 -10
-40 +20 1 -20
dB dB dB
ENHANCER
GAIN REDUCTION dB
+9
STEREO LINK
EXPANDER/GATE
TRIGGER
20
IN/OUT 1 GATE
+10 50 0
IN/OUT 2
+20 OFF +10
dB
RELEASE
10
INPUT / OUTPUT LEVEL dB
-24 -12 -6 -4 -2 -18 -6 0 +6
COMPRESSOR / LIMITER CH 2
THRESHOLD RATIO METER OUTPUT
-10 4:1 0
I/O
-30 10 2 6 -10
-40 +20 1 -20
dB dB dB
ENHANCER
+9
EX
+10 50
+20