Samson E62i Manual Del Usuario página 9

Guided Tour - E62i / E31i / E30i
Rear Panel
1: Power switch - Use this to turn the power on and off.
2: AC input - Connect the supplied heavy gauge 3-pin "IEC" power cable here.
3: Balanced XLR jack output - Electronically balanced XLR jack output. Wiring is as
follows: pin 2 hot, pin 3 cold, and pin 1 ground.*
4: Balanced 1/4" TRS jack output - Electronically balanced 1/4" TRS jack output.
Wiring is as follows: tip hot, ring cold, and sleeve ground.*
5: Balanced XLR jack input - Electronically balanced XLR jack input. Wiring is as
follows: pin 2 hot, pin 3 cold, and pin 1 ground.
6: Balanced 1/4" TRS jack input - Electronically balanced 1/4" TRS jack input.
Wiring is as follows: tip hot, ring cold, and sleeve ground.
WARNING: The XLR and 1/4" TRS inputs should not be
connected simultaneously, or loading problems may result.
* If required, both the XLR and 1/4" TRS jack outputs can be used simultaneously.
7