To reconnect your paired
handset to HouseParty
Portable Wireless using
Bluetooth:
■ If your handset was the last device to be
connected this will happen automatically.
■ Otherwise, press the Bluetooth ( ) button.
The Bluetooth ( ) LED should go out. Open
your list of paired devices on your handset
and select to connect.
Note: Only one device can be connected to the
speaker at any given time.
Wireless app-enhanced for
iOS devices:
Smarter than your average speaker, free app
available from the App Store;
■ Use your iPod touch, iPhone or iPad to
control the speaker, wirelessly. Simply pair
your device with the speaker via Bluetooth
and launch the SmartLink Wireless app.
■ Stream music wirelessly from the iPod touch,
iPhone or iPad in your hand over Bluetooth.
You can do this from the music library on
your device or through the SmartLink
Wireless app.
■ Power Management controls let you switch to
different power modes to save battery life. A
battery indicator tells you the state of charge
of the battery.
■ The Equaliser controls allow you to optimise
the speaker to your choice of music.
Charging:
■ To charge your device, please make sure your
power supply is connected to the speaker.
■ Use the USB charge port to charge your
personal electronic devices. This is
compatible with most Smartphones, Tablets
or MP3 players with 1.5A charging.
■ Charging your HouseParty Portable Wireless
from empty will take about 4 hours, longer if
other items are connected.
To change to AUX mode:
■ Press and hold the power button ( ) until an
audio tone is heard (about 6 seconds). This
indicates that the mode change is successful.
■ To return to Bluetooth from AUX mode, press
and hold the power button ( ) for 6 seconds.
For use with other
audio devices:
■ Make sure that the speaker is in AUX mode.
Please see above to change modes.
■ Plug one end of a 3.5mm audio cable (not
included) into your MP3 or MP4 player and
connect the other end into the AUX line-in
port at the back of the unit.
GEAR4 | HouseParty Portable Wireless | User Manual
3