INFOSEC UPS SYSTEM Smart Line 500 Instrucciones De Uso página 7

4. Connection
Plug Smart Line into a 2-pole, 3-wire grounded receptacle (use the original power cable of
your computer). Then connect one computer-related device into each of the power
receptacles supplied on the back of Smart Line.
5. Modem / Network Connection
Plug incoming internet line into the "IN" socket at the back of Smart Line. Use one more
Internet line cable and plug one end of the Internet line cable to the "OUT" socket at the
back of Smart Line. Plug the other end to the modem input socket as shown.
Incoming Internet
Line
6. Turn ON / Off
Press the switch of Smart Line for 1 second and the UPS turns into its normal state: the
green light is ON and the beeper is OFF.
Then it performs a self-diagnosis (the beeper and the red and green indicator lights are ON)
for several seconds.
At this time, user may turn on the PC and other loads.
Press the switch of Smart Line continuously for one second to turn OFF the UPS.
Note:
For the convenience of maintenance, please turn on Smart Line first before turning on the
PC and the other loads, and turn off Smart Line after the connected loads are turned off.
Infosec UPS System - 4, rue de la Rigotière – 44700 Orvault – FRANCE - www.infosec.fr 7
Hot Line : tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 03 05 04 206 15