Cool Mode; Energy Saver Mode - GE AEW05 Manual Del Propietário

Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for freezing outdoor
conditions. It must not be used in freezing outdoor conditions.
Remote Control
To ensure proper operation, aim the remote control at the
signal receiver on the air conditioner.
Make sure nothing is between the air conditioner and the
remote control that could block the signal.

Cool Mode

Use the Cool mode at Low, Med, High or Auto Fan Speed for
cooling. Use the Temperature Increase
the desired temperature between 64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room temperature.
The compressor will cycle on
and off to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air will become cooler.
Set the thermostat at a higher number and the indoor air will become
warmer.
NOTE: If the air conditioner is off and is then turned on

Energy Saver Mode

This mode optimizes the cooling power of your air conditioner,
thereby saving you energy. Once the set point temperature has
been reached, the fan will cycle off to save energy. The fan will
cycle back on periodically to insure all cooling capacity in the
system is used. This mode is the default mode for the unit. Each
time the unit is powered off, it will restart in Energy Saver mode
ON. This includes Delay timer mode. The first time the unit is turned
on, the settings will be 70° and Low fan. You can adjust the fan
speed and temperature to your personal comfort.
Fan Only Mode
Use the Fan Only Mode at Low, Med or High fan speed to provide air
circulation and filtering without cooling. Since fan-only settings do
not provide cooling, a Set temperature cannot be entered. The room
temperature will appear in the display.
Auto Fan Speed
Set to Auto fan speed for the fan speed to automatically set to the
speed needed to provide optimum comfort settings with the set
temperature.
If the room needs more cooling, the fan speed
Power Outage Recovery Feature
In the case of a power outage or interruption, the unit will
automatically restart in the settings last used after the power
is restored. If the Delay 1–24hr feature was set, it will resume
+ –
/ Decrease pads to set
The remote control signal has a range of
up to 20 feet.
Make sure batteries are fresh and installed correctly as
indicated on the remote control.
Remote contains a magnet allowing it to attach to metal
surfaces.
while set to a Cool setting or if turned from a fan setting to a Cool
setting, it may take approximately 3 minutes for the compressor to
start and cooling to begin.
Cooling Descriptions
For Normal Cooling
High or Med fan with a middle set temperature.
For Maximum Cooling
and High fan with a lower set temperature.
For Quieter and Nighttime Cooling
Cool mode and Low fan with a middle set temperature.
Energy Saver ON Helps minimize electricity use. It is normal for
the fan to cycle off and then back on in this mode. This on/off
cycle can repeat multiple times. Because the fan will cycle off,
you may notice a variation in room temperature and humidity.
Energy Saver OFF When this mode is not engaged, the fan will
run continuously, and in Cool mode the compressor will cycle
on and off to maintain room temperature.
NOTE: Auto Fan Speed cannot be used when in the
Fan Only Mode.
will automatically increase. If the room needs less cooling, the fan
speed will automatically decrease.
NOTE: Auto Fan Speed cannot be used when in the
Fan Only Mode.
countdown. You may need to set a new time if desired.
GEAppliances.com
Cool mode and
Cool mode
5