Troubleshooting - York JLI- 504BGY Instrucciones De Manejo

4. Operating modes
Cooling
In accordance with the differential between
the ambient and programmed temperatures,
the microprocessor starts the unit in cool
mode.
- If ambient temperature is above the indi-
cated temperature, the unit operates in
cool mode.
- If ambient temperature is below the indi-
cated temperature, the compressor turns off
and only the indoor unit fan is operative.
- Temperature scale is from 6° C to 30° C.
. Press ON/OFF button and the unit will
start.
2. Press MODE button until Cool mode is
reached.
3. Press FAN button to select fan speed.
4. Press TEMP button to adjust the unit to
the desired temperature.
Heating
- If ambient temperature is below the indi-
Problem
The unit is completely inoperative.
The unit stops after being turned on.
Does not cool sufficiently.
Does not heat sufficiently.
Indoor fan inoperative in heating mode.
ATTENTION
All data subject to change without notice.
0
cated temperature, the unit operates in
heat mode.
- If ambient temperature is above the
indicated temperature, the compressor
and outdoor unit fan turn off and only the
indoor unit fan is operative.
- Temperature scale is from 6° C to 30° C.
. Press ON/OFF button and the unit will
start.
2. Press MODE button until Heat mode is
reached.
3. Press FAN button to select fan speed.
4. Press TEMP button to adjust the unit to
the desired temperature.
Note: This function is not available on Cool
Only units.
Dehumidification (Dry)
- If ambient temperature is above the indi-
cated temperature, the unit operates in
cool mode.
- Temperature scale is from 6° C to 30° C.
. Press ON/OFF button and the unit will
start.
Cause
- No power supply.
- Main switch is off.
- Power supply is insufficient.
- ON/OFF set to OFF.
- Control system failure.
- Condensing unit air intake or discharge obstructed.
- Incorrect operation of control circuit.
- Outdoor temperature is above 43° C in cool mode.
- Dirty air filter.
- Too many sources of heat in the room.
- Doors or windows open.
- Air intake or discharge obstructed.
- Temperature set too high.
- Refrigerant leak.
- Trouble with the temperature sensor.
- Dirty air filter.
- Doors or windows open.
- Air intake or discharge obstructed.
- Temperature set too high.
- Refrigerant leak.
- Outdoor temperature is below -5° C.
- Incorrect operation of control circuit.
- Pipe sensor in incorrect position.
- Pipe sensor off.
- Damaged pipe sensor cable.
- Electric capacitor leakage current.
Your product is marked with this symbol. This means that at the end of its service life it should not
be mixed with the non-classified household scrap. Disposal of same should be carried out cor-
rectly and in an environmentally respectful way, in compliance with the corresponding local and
national regulations.
This means that the user is under the obligation of handing the used product over to a waste disposal
organization authorized by the local authorities, for transportation to an adequate waste treatment
plant. Should the withdrawal of this product be due to its replacement by a new product for a similar
use, you can give the used product to the distributor of the new unit for waste disposal.
For further informaiton, contact your local authorities.
2. Press MODE button until Dry mode is
3. Press TEMP button to adjust the unit to
Fan
- Temperature cannot be modified in this
. Press ON/OFF button to turn the air
2. Press MODE button until Fan mode is
3. Press FAN button to select fan speed.
Trouble shooting
Should the air conditioning unit not operate
correctly, please check the following points
before contacting your technical service.
GB
reached.
the desired temperature.
operating mode.
conditioning unit on.
reached.