Samson Auro D1200 Manual Del Usuario página 12

Controls and Functions
1
7. LPF (Hz) - Adjusts the low frequency filter
3
end range of the subwoofer from 80Hz-
200Hz. This setting does not affect the
signal sent to the THRU outputs.
8. DSP - The Auro D1200 DSP has three
EQ contour curves: NORMAL, DEEP, and
BOOST. The NORMAL setting produces
the standard frequency response for the
subwoofer and works best for most applications. BOOST enhances frequen-
cies at 100Hz to add punch and strengthen the kick drum frequency band.
The DEEP setting extends the low frequencies down to widen the range of the
subwoofer.
Note: While the DEEP setting might increase the low frequency response of the
Auro D1200, low frequencies use more power and reduce the overall headroom
of the amplifier.
9. POLARITY Switch - Use this switch to set the polarity of the amplified signal. In
the NORMAL setting, there is no change to the signal. When the switch is set to
the in REVERSE setting, the signal's polarity is changed by 180°. The setting of
the POLARITY switch has no effect on the signal sent to the THRU outputs.
10. AC INPUT - Connect the supplied standard IEC AC power cable here.
11. POWER Switch - Switches on the Auro D1200 main power.
12. Voltage Switch - Slide to change the operating voltage from 115 to 230 volts.
12
3
6
6
5
4
4
10
10
7
7
8
5
11
11
9
8
9
12
12